Interface Modules
General Purpose Relay Modules, Relay Interface Modules - Standard/Special, Solid State Isolated/Non-isolated Modules, Opto Interface, Diode/ Resistor Modules, Proximity Sensor Interface
General Purpose 1/2 C/O Contacts
Interface Modules - Standard
Interface Modules - Special
Solid State Isolated/Non-isolated Modules
Opto Interface Module
Diode/ Resistor Modules
Industrial Interfacing
Available in 1 /2/3/4 Change Over contacts Rated Contact Switching current up to 48A Coil Voltage available DC : 5/12/24/48/60/80/110/125/ 220 V AC: 6/12/24/42/48/60/80/110/115/120/127/220/ 230/240 Versions with coil overvoltage suppression Versions with Flag indicators & Manual relay Test Push Buttons with the possibility of latching the normally open contacts closed Mounting on PCB
Industrial Relays
Miniature Relays
Photovoltaic Systems
Forcibly Guided Contact Relays
Voltage Monitor Relay
- Monitors DC input voltage and triggers internal timer when input voltage goes above set voltage
- After Set time delay (0-60 sec), Relay change over occurs.
- Voltage Monitoring, Dynamic Braking Resistor Protection
- Resets if input voltage comes down below set voltage
Protection Relays
Phase Sequence Relay, Voltage Protection Relay
- Monitors Phase Sequence, Phase Failure, L-L Under/Over Voltage
- 3Ø / 3 Wire Input
- Protection Against Output Short Circuit, Overload & Overvoltage
- DIN Rail / Base Mounting